Grohe Adagio Inlet Float Valve Diaphragm Washer 4375800M
If your Grohe inlet valve won't shut off properly it could very well be that the diaphragm washer inside of the valve needs to be replaced.
Over time as the valve is continuously opening and closing, small tears can start to form in the diaphragm washer, in turn the diaphragm washer will no longer give a good seal. And debris in the water supply (which can be commonly caused by nearby work being carried out on the water supply) can also contribute overtime to this washer being worn.
Many make the mistake of purchasing a full replacement inlet valve at the first sign of any issue, replacing just this washer may save you a lot time and money in the long-term.
We advise purchasing a couple of these washers at a time so you've got one readily available in the event that the washer fails again in future.
Thickness: 25mm (Including both red tips)
Materials: Rubber and plastic.
Suitability: Suitable for all Grohe Adagio inlet valves.